- Decide before the job whether any closed space may need entry, and who makes that call.
- Try to find the fault from outside first, with the tools and information you already have.
- Name one person to stay at the opening for as long as anyone is inside.
- Agree the stop conditions, the exit route and the emergency call details before anyone climbs in.
A closed crane compartment is a space with limited openings that was never designed for people to work in. The UK case below shows how quickly one can turn deadly. Two men went into a closed crane compartment to find out what was wrong with its hydraulics. Within a minute, one of them had passed out. Three men were eventually pulled out by the emergency service, and two of them died. Almost every step in it can happen on an ordinary service call: a fault is found, someone decides the answer is inside a closed space, and people go in without a clear plan for getting out.
Key takeaways
What the HSE account describes
The HSE's introduction to working in confined spaces opens with the key fact: "Having identified a fault in a crane's hydraulics, 2 men accessed a closed compartment."
Notice the order. The starting point was a fault. Entry came afterward, as a way to deal with it. A diagnosis that leads a person into a closed space is a decision, and it should be treated as one, with the same care you would give any other decision about who goes where and why.
The page then describes what happened inside: "Within a minute of entering the compartment, one had passed out and the other was feeling lightheaded but managed to escape." (HSE summary) The change came within a minute. A crew cannot count on having time to notice a problem and step back once they are inside, so the plan has to work from the first moment of entry.
The account ends with the outcome: "The 3 men were extracted by the emergency service but 2 of them died." (HSE summary)
Read it closely. It describes 2 men accessing the compartment and 3 men being extracted. The page does not explain that difference, and this post will not guess at it. The headline figure, two of the three men who were pulled out died, matches the page's own wording. If you use this case in training, check the original before you repeat a head count.
The account is also brief. It does not give the cause of death, the rescue timeline, the substance involved, or the controls that were in place. Say what the page says and stop there. A lesson built on guesses about missing details will teach the wrong thing.
Why a closed compartment is different
A closed compartment is not just a small room. Its openings are limited, air does not move through it the way it does in an open bay, and you often cannot tell what is inside until you open it or get in. A hatch shut for weeks, or a box that has held water, dust or fluid, can look exactly like a hatch that is safe.
The HSE page makes clear that the danger list is wider than bad air: "Other dangers may include flooding, drowning or asphyxiation from some other source such as dust, grain or other contaminant." (HSE summary) Water can be a hazard, not just air. Asphyxiation, meaning the body is not getting enough oxygen, can come from a source other than a gas leak. A technician who is only thinking about fumes may miss the rest of the list.
Your senses are not a reliable test. A space can smell of nothing and still be unsafe, and a tech who feels fine on the way in has not proved the air is fine. One man in the HSE case passed out within a minute of entering. A quick look is not a safe test.
For dispatchers and team leads, the lesson is simple. "Closed" describes how the space is accessed. It does not tell you what hazard is inside, and nobody on the phone or at the hatch can be sure from outside.
What the air can do to people
When a space is closed, what is inside can affect how a person thinks, moves and breathes. WorkSafe New Zealand's advice on respiratory protective equipment says that "Depending on the substance, the effects can be immediate or long term." (WorkSafe NZ, Advice for businesses) The same page sorts the effects into two groups, shown below.
| Type of effect | Examples given by WorkSafe NZ |
|---|---|
| Short-term (acute) | Headaches, forgetfulness, drowsiness, feeling dizzy and sick, mood changes, eye and skin irritation |
| Long-term (chronic) | Sleep disorders, memory loss, cancer, organ damage, fertility problems, death |
Source: WorkSafe NZ, Advice for businesses
Two points follow. Short-term effects are a warning, not a nuisance. A tech who becomes drowsy, dizzy or sick inside should come out, and the people at the opening should know it has happened. The long-term column shows that some harms are not felt at the time, which is why a plan and a check of what is in the space matter more than how someone feels.
The HSE case sits at the fast end of this picture. One man passed out within a minute, and the other felt lightheaded before getting out. The summary does not link either effect to a specific substance, so read the case as a reminder of how quickly a bad atmosphere can act, not as a diagnosis.
"Depending on the substance" matters for planning too. You cannot judge the likely effects without knowing what is in the space, and a crane compartment may hold more than one kind of material. Finding out what is there is part of the job.
Once the hazards are known, the response has to be specific. Washington State's rules set out the controls for some hazards: "These precautions include providing proper respiratory protection or ventilation in accordance with chapter 296-842 WAC." (Washington State Legislature, WAC 296-155-655) Ventilation and respiratory protection are the controls to ask about before anyone enters, not something to improvise at the hatch.
Common mistakes on a service call
Incidents like this one often start with a sequence of reasonable-looking decisions rather than one obviously reckless act. These are the patterns that tend to lead a crew into a space without a plan:
- The hatch is the only way to see the fault. The tech wants a look, so the hatch comes open. Ask first whether the fault can be narrowed down from outside, with the tools and information you already have.
- The customer is waiting. Time pressure pushes people toward the fastest option, and the fastest option is often the entry. A delay is usually cheaper than an incident, so owners and dispatchers should make that trade-off clear before the job, not during it.
- Someone goes in to help. A colleague who does not come out gets followed by another person who wants to help. The second entry is a common way one problem becomes two. Decide before the job that nobody goes in without a plan for their own exit.
- Nobody is watching the opening. If the person at the hatch is also doing the lifting, the diagnosing or the paperwork, nobody is really watching the tech inside. One person should stay at the opening for as long as anyone is inside.
- The plan lives in someone's head. A plan that only the senior tech knows is not a plan for the crew. Say it out loud, write it down, and make sure everyone on site has heard it.
None of these mistakes requires bad intent. They are ordinary habits, which is why they need naming before the job starts rather than being left to judgement at the hatch.
Plan before anyone opens the hatch
The best time to deal with a closed space is before anyone is near it. Work through these questions with the tech before the job starts, and write the answers down. For the hazard checks behind the first two questions, see confined space hazards before dispatch.
| Question | What to write down |
|---|---|
| Can the fault be found without going in? | The checks tried from outside, and what they showed |
| What is the compartment, and what has been in it? | Hydraulic fluid, dust, grain, water or anything else the crew can identify |
| Who is at the opening, and who knows where the tech is at all times? | One named person and the check-in method |
| How will the tech get out, and how will the crew reach them if they cannot get out alone? | The exit route and the rescue route |
| What will the crew do if someone feels dizzy, drowsy or sick, or stops answering? | The stop condition and the first action |
| Who calls emergency services, and what do they say? | The address, access route, name of the tech inside, and what is known about the space |
Keep the plan short. A plan that needs a binder will not be read at the hatch. One page, with the stop conditions at the top, is usually enough.
Define the stop conditions in advance. A stop condition is a specific thing that makes the crew leave the space and stop the job, such as someone feeling unwell, a change in what is found inside, or a sign that the plan no longer fits. If the stop condition is only decided once the job is going wrong, people will hesitate. If it is agreed beforehand, the decision is already made.
Rules for confined spaces differ by country, region and industry, and a rule set can have more than one layer. Treat this post as a checklist of questions, not a statement of what the law requires where you are.
Rescue needs its own plan
The HSE summary says the emergency service did the extraction. That is a fact to plan around, not a plan. The summary does not describe how the extraction happened or how long it took, so do not assume the outcome of a call.
Reporting needs planning too. WorkSafe New Zealand's welding guidance is direct about what to do after a death: "If someone has been killed, call 0800 030 040 immediately." (WorkSafe NZ, Health and safety in welding) That page covers welding, not crane compartments, but the lesson carries over. Find the right number before the job and write it on the plan, rather than searching for it on the day.
Team leads should make sure that, before anyone enters, the crew knows where the emergency call will come from and what the first person to call will say. The address, the access route, the name of the tech inside and what is known about the space are the details that save time when a call is made under stress. For a related routine, see emergency action plan for a new tech review.
Team leads should also decide that nobody goes in after a colleague without a plan for their own exit. A rescue attempt that starts with an unplanned entry can turn one casualty into two. The HSE summary does not describe a second entry in this case. This is a general point, not a finding about the incident, and it is the one most worth drilling into a crew.
Finally, decide who stays at the opening and what that person is allowed to do. A good answer is that they stay put, keep talking to the tech, watch for changes, and call for help without going in. That role should not be shared with the lifting or the diagnosis.
Dispatch and team lead checklist
Dispatchers decide what a tech knows before they arrive, and that is often the only chance to avoid a surprise. The Field Service Work Order Checklist for Dispatch Handoffs covers the handoff details. Before a crew is sent, dispatch should:
- Flag any job where the work may need a hatch, a box, a pit or any enclosed area to be opened or entered, even if the call sounds routine.
- Ask the site contact whether anything has been stored in or leaking into the space, and write down what they say.
- Tell the tech that the job may involve a closed space, so they arrive with the right plan and equipment in mind.
- Do not let the tech start work inside the space until the plan has been agreed with the team lead.
- Record the decision, including who agreed the plan and when.
Here is an illustration, not a description of the HSE case. A call comes in that a crane will not raise a load. The site contact says the hydraulics have been "acting up" and the crew will need to get inside the housing to see what is wrong. A good dispatcher asks what the housing holds, whether it has been wet, whether anything has been stored in it, and whether the fault can be checked from outside first. The dispatcher passes the answers to the team lead before the crew sets off. The job has not changed, but the decision about entry is now made by the people who should make it, before anyone is at the hatch.
Once the crew is on site, team leads should:
- Confirm the plan before the work starts, not after the tech is already at the opening.
- Assign one person to stay at the opening for as long as anyone is inside, and keep them there.
- Brief the crew on the signs of a bad atmosphere, including dizziness, drowsiness, sickness and sudden confusion, and tie them to the table in this post.
- Stop the job the moment the plan no longer fits what is found, even if the job is nearly finished.
- Agree in advance who checks on a tech who has come out, and what the crew does next, before anyone goes back in.
The final point is about authority. A team lead needs to be able to stop a job without being told it is a waste of time. If the crew knows that calling a stop is expected rather than awkward, they are far more likely to use it.
What owners should put in writing
Many of the decisions in this post are made, or not made, at the owner level. The WorkSafe NZ page on working near low voltage overhead electric lines notes that the Health and Safety at Work Act 2015 (HSWA) gives workers a number of rights and responsibilities. (WorkSafe NZ, Working near low voltage overhead electric lines) For owners, the practical point is that a procedure should say what a worker can do, not only what they must do. Put the following in writing, in plain words, where every tech and team lead can find it:
- Which types of job may involve a closed space, and who decides when an entry is needed.
- What equipment and training the business provides, and what it expects the tech to bring to the job.
- Who a tech contacts when they are unsure, and who they can call to stop the job.
- How incidents and near misses are reviewed, and how the plan is changed as a result.
- A clear expectation that a tech can refuse an unplanned entry, and that doing so will not count against them.
Owners should also read the full HSE and WorkSafe NZ pages before writing their own procedures, rather than relying on this summary. The summary is a starting point, not a substitute for the source.
Owners who run several crews should check that every team has the same plan, because the crew that gets the call on a Friday afternoon is often the one that has not been briefed. A procedure that exists only in the head office is not one the tech can use on the roof of a crane.
Next step today: pick one closed space your crews are most likely to be sent to, and write down the answers to the six questions in the planning table for it before the next call comes in.
Frequently asked questions
Is a closed crane compartment always dangerous?
Not always, but treat it as a possible hazard, because you often cannot tell what is inside until you open it or get in.
Can a tech tell if the air is safe by smell or feel?
No. A space can smell of nothing and still be unsafe, so a quick look or a feeling of being fine is not a safe test.
What should be written down before anyone enters?
Write down whether the fault can be found from outside, what the compartment holds, who is at the opening, the exit and rescue routes, the stop conditions and the emergency call details.
Where to read the sources
- HSE, introduction to working in confined spaces: the source for the crane case and the wider danger list.
- WorkSafe NZ, Advice for businesses: the source for the short-term and long-term effects of harmful substances.
- Washington State Legislature, WAC 296-155-655: the source for the respiratory protection and ventilation controls, and the pointer to additional requirements.
- WorkSafe NZ, Health and safety in welding: the source for the reporting instruction after a death.
- WorkSafe NZ, Working near low voltage overhead electric lines: the source for the summary of workers' rights and responsibilities under HSWA.
Two of three men died in a case that started with a fault. The entry was not the job; it was a response to the job. Plan the entry before the fault leads anyone inside.