- Find the wage determination in the contract and save a dated copy.
- An option year takes its rate from the determination effective for that option, not from the first year.
- Where the Executive Order 14026 clause applies, compare its minimum with the determination rate for each classification and use the higher one.
- Record which rule you applied, with the date and source document, for each period.
- Ask the contracting officer in writing when the documents leave a gap.
Under a federal construction contract, the wage rate depends on the contract's wage determination, the period you are in, and any applicable Executive Order minimum. The wage question is not "what do people usually get paid around here?" It is "which wage rules does this contract carry, and which period am I in right now?" Those two answers decide the rate you must pay. Many owners and team leads learn this the hard way. An option year starts, nobody updates the pay sheet, and the crew keeps the rate from the first year.
This post covers three rules that sort out most of the confusion. It is a practical guide for owners and team leads, not legal advice. The contract documents and the official text of the Federal Acquisition Regulation (FAR) control. Follow the links in each section and read the wording yourself before you change a rate.
Key takeaways
Where these rules come from
Federal construction contracts bring in labor standards through contract clauses and through the FAR. The FAR's labor standards section for construction work is Subpart 22.4. It points readers to the definition of "construction, alteration, or repair" in section 22.401, and it includes a warning that matters for planning: "Labor relations requirements prescribed in other subparts of part 22 may also apply." Subpart 22.4 of the FAR
In other words, one contract can carry more than one set of wage requirements. Do not assume the first document you find is the only one. The three rules below cover the questions that most often decide the rate: the starting determination, the option-year determination, and the Executive Order minimum.
Rule 1: The contract's wage determination sets the starting rate
The main construction wage clause is FAR 52.222-30, titled "Construction Wage Rate Requirements-Price Adjustment (None or Separately Specified Method)." The title signals that the clause deals with price adjustment, so read how your contract handles that before you assume a wage change will flow into your price. FAR 52.222-30
The clause starts by pointing to the governing rate. It refers to "The wage determination issued under the Construction Wage Rate Requirements statute by the Administrator, Wage and Hour Division, U.S. Department of Labor." That determination is the reference point for the wages on the job. It is not a number you pick from a local survey, from a past project, or from what a subcontractor quoted you.
For the initial term, work through these steps:
- Find the wage determination in the contract documents and save a dated copy.
- Map every job title on the crew to a classification in that determination. If a worker's title does not match any listed classification, get an answer from the contracting officer before you pay that worker.
- Compare the rates on your payroll records with the determination for every classification you use.
Pay attention to what the crew actually does, not only to what the job title says. If a worker's duties look like a different classification on the determination, that question needs an answer from the contracting officer, not a decision made on the job site. A foreman's judgment is useful, but it is not the same as the contract's answer.
This rule is simple, but it is the one teams skip when the job looks routine. Keep the copy with the contract file so that anyone who joins the team later can see which determination you used and why.
Rule 2: An option year follows the determination effective for that option
Many federal contracts run a base period and then one or more option periods that extend the term. The question of which wage rate applies to an option is the second rule, and the clause answers it directly. Under FAR 52.222-30, a Department of Labor wage determination "that is effective for an option to extend the term of the contract, will apply to that option period." FAR 52.222-30
Two words in that sentence do the work: "effective" and "option." The test is which determination is effective for the option. It is not automatically the one that governed your first year, and it is not necessarily the one you used when you priced the bid. An owner who keeps paying the base-period rate into an option year may be underpaying, even if nobody noticed at the time.
A simple way to think about it: picture a base year at one set of rates and a later option year where the determination has changed. The option year does not inherit the earlier rate out of habit. It takes its rate from the determination that is effective for that option. Each period needs its own check.
When an option is in view, do three things:
- Ask for the determination that applies to the option period before the option is exercised, so the crew is not working under a rate nobody has confirmed.
- When the option is exercised, update the rate sheet and the payroll setup promptly, before the first payroll that covers the new period.
- Keep a note of which determination you assumed in your bid, so you can explain any difference later.
Pay close attention to the turn between periods. The gap between the end of one period and the start of the next is where most surprises happen. Put the option decision on your calendar well before the current period ends, and make sure the rate question is answered before anyone sets the first pay period under the new term. A question raised late is always harder to settle than one raised early.
Rule 3: The Executive Order 14026 minimum can set a higher floor
The third rule covers a second, separate minimum wage. FAR Subpart 22.4 explains that the clause at 52.222-55, Minimum Wages for Contractor Workers under Executive Order 14026, "requires the E.O. 14026 minimum wage rate to be paid if it is higher than other minimum wage rates, such as the subpart 22.4 statutory wage determination amount." FAR Subpart 22.4
The practical test is a comparison. For each classification, you have the rate from the wage determination, and you may also have the Executive Order minimum. The clause's requirement is tied to the higher of those rates, so the comparison is what you need to document for each period.
This rule applies only where the clause is in your contract. Check the clause list in the contract before you run the comparison. If the clause is not there, the comparison does not apply to that work. Do not assume it because a neighboring contract had it.
A useful habit is to write the comparison as a short table, with one row for each classification and columns for the determination rate, the Executive Order rate, and the rate you actually pay. The table makes it obvious when the Executive Order rate changes the answer, and it gives an auditor or a new team lead one page to read instead of a stack of emails.
| Classification | Determination rate | Executive Order rate | Rate you pay |
|---|---|---|---|
| Example | Rate from the determination | Rate from the Executive Order clause | Higher of the two |
Illustrative example: a timeline for a base year and two option years
Consider a contract with a base year and two option years. The amounts do not matter for this example. The sequence does.
- At award: Confirm the wage determination for the base year. Map your classifications to it, and check whether the Executive Order clause is in the contract.
- Before the base year ends: Find out which determination is effective for the first option. If the documents do not answer that, ask the contracting officer in writing.
- When the first option is exercised: Update the rate sheet and payroll setup for the new period. Run the Executive Order comparison again if the clause applies.
- Before the second option: Repeat the same steps. Do not carry the first option's numbers forward because they were correct last year.
Each change point is a chance to be wrong. Build the check into the calendar so it happens on a schedule, not only when someone notices a problem.
Pricing option years in a bid
Option years are part of what you price, so the wage assumptions behind them should be explicit. Write down which wage determination you used for the base period and for each option period. Note the labor cost assumptions that come from those determinations. For timing around wage changes, see Public bid wage changes: 2 timing windows to watch.
If a determination for an option period is not available when you bid, say so in your internal notes and treat it as a risk to plan for. Do not fill the gap with a guess and forget about it. A written assumption is much easier to manage during performance than a number that nobody remembers choosing.
How the three rules fit together
For each period of the contract, run the same short sequence:
- Identify the period: the base year or a specific option.
- Find the wage determination that is effective for that period, and map each classification to it.
- Check whether the Executive Order 14026 clause is in the contract. If it is, compare its minimum wage rate with the determination rate for each classification, and use the higher one.
- Check whether labor relations requirements from other part 22 subparts may also apply. The FAR notes that they "may also apply."
- Record the result with the date and the source document you used.
The routine takes a few minutes for each period. It saves a lot of arguments later, because every rate on the pay sheet can be traced to a document in the file.
Apprentices and probationary workers
Apprentices raise their own questions. FAR Subpart 22.4 describes a narrow case that involves a worker "in the first 90 days of probationary employment as an apprentice in an apprenticeship program, and is not individually registered in the program, but who has been certified by the OATELS or a State Apprenticeship Agency (where appropriate) to be eligible for probationary employment as an apprentice." FAR Subpart 22.4
Read that sentence as a list of conditions. The worker has to be within the first 90 days, in probationary employment, not individually registered in the program, and certified as eligible by the named body. If any one of those conditions is missing, do not assume the apprentice treatment applies. Get the certification in writing and keep it in the file with the start date of the probationary period.
Apprentice status can also be a source of payroll errors. Check each worker against these conditions for each new contract, not only for the contract that first brought them onto the crew. For related pay questions, read Apprentice and trainee pay below journeyman rate: 3 paths.
Common mistakes to avoid
Most wage problems on federal work come from a short list of habits. Watch for these:
- Copying the rate sheet from the last job into a new contract without checking the classifications.
- Assuming the option-year rate is the same as the base-year rate.
- Relying on a phone call or a text message about which determination applies, with nothing in writing.
- Running the Executive Order comparison once at the start and never again.
- Handing a subcontractor the work without giving them the same determination and wage requirements.
- Waiting for a worker, an auditor, or a complaint to raise the question.
Each of these is easy to prevent with a checklist and a folder. None of them is hard to fix if you catch it early, and most become harder to untangle the longer they run.
Keep records that show which rule you applied
If a question comes up later, your records are your defense. Keep these together in one folder for each contract:
- The wage determinations in the contract, with the date you received each one.
- Every option notice and the date the option took effect.
- Your classification map, with the date it was last updated.
- Apprentice certifications and the start date of each probationary period.
- Payroll records that show the rate paid for each classification in each period.
- Your notes on the Executive Order comparison, including both rates and which one you used.
Someone who joins the team later should be able to answer "which rule applied in this period?" from the folder alone. If the answer depends on one person's memory, the process is not finished yet.
Related guides: Asbestos pipe amount: the 260-foot federal line · 2 counts that set Maine public-works wage fines for a crew.
Questions to ask the contracting officer
When the documents leave a gap, ask. Good questions include:
- Which wage determination applies to the base period, and which applies to each option period?
- Is the Executive Order 14026 clause in this contract, and if so, what minimum wage rate does it set for this period?
- Do any labor relations requirements from other part 22 subparts apply to this work?
- How should a worker be documented if they are in a probationary apprenticeship period?
Put each question in writing and save the reply. A written answer is much easier to rely on than a phone call, and it gives you something to show an auditor, a subcontractor, or a new team lead.
Your next step today: open the contract file, find the wage determination for each period, and save a dated copy with your classification map beside it.
Frequently asked questions
Which wage rate applies to an option year?
An option year takes its rate from the wage determination that is effective for that option. It does not automatically keep the rate from the base period.
Does the Executive Order 14026 minimum always apply?
No. It applies only where the clause at 52.222-55 is in your contract, and then the E.O. 14026 rate must be paid where it is higher than other minimum wage rates.
Should wage answers be in writing?
Yes. Put each question to the contracting officer in writing and save the reply, since a written answer is much easier to rely on than a phone call.
Bottom line
Three rules cover most of the confusion on federal construction work. The contract's wage determination sets the starting rate. An option year follows the determination that is effective for that option, not the rate from the first year. Where the Executive Order 14026 clause applies, its minimum wage rate governs when it is higher than the other minimum rates.
Check each period separately, keep the records together, and ask the contracting officer when the documents leave a gap. This post is general information for planning. It does not replace your contract or the official text of the FAR.