- Decide whether a worker is covered by their primary duties, not their title.
- Do not assume every supervisor is excluded; read paragraph (1)(iii) first.
- Treat a site as outside the rule only if it would keep operating without regard to a particular federal contract.
- Write down the task split and the location facts, and ask the contracting officer when a case is unclear.
Two groups can fall outside a federal labor standards definition: certain office-type and supervisory workers, and certain permanent sites. Check each one before you assign people or sites.
Key takeaways
Why this definition matters on your crew
If your crew works under a federal construction contract, the rules you follow depend partly on two questions: who counts as a covered worker, and where covered work happens.
The Federal Acquisition Regulation (FAR) labor standards subpart addresses both questions. It starts by saying it "implements the statutes which prescribe labor standards requirements for contracts in excess of $2,000 for construction, alteration, or repair, including painting and decorating, of public buildings and public works." (FAR Subpart 22.4)
Team leads and dispatchers sit between these two groups, so they get their own section.
Owners, dispatchers, and team leads often make these calls on the fly. A dispatcher sends someone to the yard, a lead pulls an office worker onto a site for a day, or an owner moves a shop closer to a job. Each of those moves can change the answer. A short written check before the assignment is much easier than sorting it out after payroll closes.
This is a plain-language guide, not legal advice. The contracting officer, the awarding agency, and your own counsel decide how a specific contract applies.
Group one: people whose main work is not manual
The first group is people. The FAR definition excludes workers "whose duties are primarily executive, supervisory (except as provided in paragraph (1)(iii) of this definition), administrative, or clerical, rather than manual." (FAR Subpart 22.4)
Three parts of that sentence do most of the work.
"Primarily." The test looks at what a person mostly does, not at a title. A person who spends most of the week on bids, payroll, and schedules is in a different position from someone who spends most of the week on tools, even if both carry the word "lead" on their paperwork.
"Manual." The exclusion is built around the contrast between office-type work and hands-on work. A worker who spends most of the day doing physical construction tasks is the kind of worker the definition is written to cover.
The exception. The supervisory category carries its own exception, which points to paragraph (1)(iii) of the same definition. Read that paragraph in the full definition before you decide a supervisor falls outside it.
A practical way to sort people:
- Write down each person's tasks for a typical week, with rough hours for each.
- Mark each task as hands-on or office-type.
- Compare the totals and decide by the larger share. Write the reason in the job file.
- Re-check when a role changes. A dispatcher who starts driving a truck every morning is not the same case as the dispatcher you assessed last quarter.
Group two: sites that sit outside the work
The second group is places. The definition excludes:
> permanent home offices, branch plant establishments, fabrication plants, or tool yards of a contractor or subcontractor whose locations and continuance in operation are determined wholly without regard to a particular Federal contract or project. (FAR Subpart 22.4)
Four kinds of places are named. The test attached to them matters more than the names. Three words carry it: "locations," "continuance," and "wholly."
"Locations and continuance in operation" means two questions. Where is the facility, and how long will it keep running? Both have to be answered without regard to a particular federal contract. A shop you chose and would keep running for your general business is in a different position from a yard you set up for one job and plan to close when that job ends.
"Wholly" is a strict word. If a contract played any real part in deciding where a facility sits or how long it runs, the exclusion is harder to claim. Partial contract influence is a warning sign, not a free pass.
Three plain examples show how the test plays out. These are illustrations, not rulings.
- A home office that runs bookkeeping and dispatch all year for the whole business, with no link to one contract, is the kind of place the exclusion describes.
- A tool yard leased for one federal project is a weak fit. Its location and its life were set by that project.
- A fabrication shop moved closer to a job so that a contract's fabrication work can happen nearby is a hard case. The contract drove the location, so the answer depends on the facts and on the contracting officer's reading.
The definition also names "branch plant establishments." If you run a branch location, ask the contracting officer in writing how it is treated on your job.
If a site does not clearly meet the test, treat the work done there as covered until someone with authority says otherwise. Keeping a site outside the rule on a guess is the expensive mistake.
Where team leads and dispatchers fit
Team leads are the hardest case. Many run a crew and also swing a hammer. Under the primary-duties test, a lead whose days go mostly to supervising may fall in the supervisory category, subject to the exception described above. A lead who spends the majority of the week on the tools is doing manual work, and the title will not change that. Write the split down, because the same person can land on different sides of the line in different weeks.
Dispatchers usually work from a phone, a screen, and a schedule. Their work may read as clerical. But a dispatcher who regularly loads trucks, stocks the yard, or drives out to fix a problem is doing manual work during those hours. Decide by what the person actually does in a typical week, and recheck when the job mix changes. For dispatch handoff records, see Field Service Work Order Checklist for Dispatch Handoffs.
Owners who work on the crew face the same test as anyone else on it. An owner whose days go to bids, banking, and paperwork is in the office-type group. An owner who spends time on the job with tools is judged by the same measure as a crew member. Owners often skip the written check because they feel they already know their own roles. The written check is still the safer path.
Worked examples
These short scenarios show the reasoning. They are invented for teaching.
Scenario one: the split lead. A team lead spends about half the week running the job, including laying out work and checking inspections, and the other half on tools alongside the crew. Neither half clearly wins, and the title does not settle it. The practical step is to log hours for several typical weeks, see which share is larger, and ask the contracting officer how the supervisory exception applies before classifying that lead.
Scenario two: the dispatcher who drives. A dispatcher works the phones most mornings but drives a service truck to a site two afternoons a week. Those afternoons are hands-on. The record should show both, so the answer rests on the real split rather than on the job title.
Scenario three: the yard for one job. An owner rents a yard for a single federal project and plans to close it when the project ends. The yard was set up for that project alone, so the exclusion is hard to claim. Treat the work done there as covered, and document why the yard was chosen.
Illustrative example: one lead's typical week
A lead logs 12 hours in a typical week: 7 on tools and 5 on bids and scheduling. Hands-on work is the larger share, so the primary duties that week are manual, and the title does not change that. Repeat the log for several weeks before you classify the lead.
Common mistakes to avoid
- Trusting the title. "Office manager" or "lead" does not decide the question. Duties do.
- Assuming all supervisors are excluded. The supervisory category has an exception. Read paragraph (1)(iii) of the definition before you rely on the supervisory exclusion.
- Treating every facility as excluded because it is yours. The test asks whether a site would exist without regard to a particular contract. Ownership alone does not answer that.
- Setting up a yard, shop, or office for one job and calling it permanent. The phrase "continuance in operation" points to how long the place will really run.
- Making the decision once and never revisiting it. Roles and sites change mid-job. Recheck whenever assignments change.
- Forgetting subcontractors. The compliance duty reaches subcontractors too, as covered below.
Pay and pressure: the kickback rule
Leads and dispatchers control hours, assignments, and schedules, which gives them real leverage over workers. The FAR subpart addresses that leverage directly. It describes a federal prohibition on inducing a worker employed on covered public construction "by force, intimidation, threat of procuring dismissal from employment, or otherwise" to "give up any part of the compensation to which that person is entitled under a contract of employment." (FAR Subpart 22.4)
In plain terms, do not ask a worker to hand back part of a paycheck. Do not threaten to cut hours, move someone to a worse job, or fire anyone to get money back. Do not let a lead or dispatcher do it on your behalf. Treat a request from a lead or dispatcher the same as one from you, and stop it.
If you are a subcontractor
The FAR subpart also explains how the compliance duty is passed down. It says that "contracts subject to the Copeland Act shall contain a clause (see 52.222-10) requiring contractors and subcontractors to comply with the regulations issued by the Secretary of Labor under the Copeland Act." (FAR Subpart 22.4)
That means the requirement is written into the contract, and it reaches subcontractors. If your company is a subcontractor, check the clauses in your own subcontract. Do not assume that the prime contractor's compliance covers your crew, your yard, or your office. If you cannot find the clause, ask for its text in writing.
What state rules can change
Federal rules are one layer. State prevailing wage rules are separate, and they vary. A state rule can define covered workers, exempt work, and sites differently from the federal subpart.
Ohio's code, for example, describes a carve-out for public work done with donated labor. One clause reads "Any portion of a public improvement undertaken and completed solely with labor donated by the individuals performing the labor," (Ohio Laws and Administrative Rules) and it goes on to name who may donate that labor. Read the whole clause before you rely on it. A federal answer does not tell you whether a donated-labor arrangement in Ohio gets the same treatment.
California works differently again. Its Department of Industrial Relations sets out a lookup order for prevailing wage classifications, and the county where the work happens comes into play when earlier steps do not match: "If you have not found your craft in steps 1, 2, or 3, choose the county where work is being performed to examine the subtrades." (California Department of Industrial Relations) Location matters under that state's process as well, but in a different way than under the federal test.
Before a job starts, find out which rule governs: federal, state, or both. Ask the awarding agency to confirm in writing, and keep the answer in the job file. A federal answer is not a safe stand-in for a state answer, and the other way around.
A simple check before you assign people or sites
- Confirm the contract. Check whether it is a federal construction, alteration, or repair contract above the threshold quoted above.
- List each person's primary duties. Note the rough split of hands-on and office-type work in a typical week.
- List each location. Ask whether it would exist and keep operating without this contract.
- Check state rules. Confirm whether a state rule also applies, and whether it treats these people and places the same way.
- Record the decision. Write the date, the facts, the reasoning, and who approved it.
- Ask when unsure. Send the question in writing and wait for an answer before you assign the person or site.
Keep records that show your reasoning
Keep the task split, the location facts, and the decision note together with payroll and time records. Time records that show hours by task make the primary-duties question much easier to answer later. For a time-record example with hour fields, see Record 7 hour fields before you approve today's time. If a dispute or audit comes up, dated notes made at the time are easier to defend than a reconstruction written months later.
Your next step
Today, pull up your current crew list and write each person's tasks for one typical week, with rough hours for each. That one list shows which roles need a closer look.
Related guides: Asbestos pipe amount: the 260-foot federal line · California outdoor heat rules: 3 duties for crews · Check 8 booking rules before recurring jobs generate.
Frequently asked questions
Are all supervisors excluded?
No. The supervisory category has an exception that points to paragraph (1)(iii) of the definition, so read that paragraph before you decide.
Does owning a shop or yard keep it outside the rule?
No. A shop or yard qualifies only if its location and continuance are determined wholly without regard to a particular federal contract, and ownership alone does not answer that.
Do state rules change the answer?
Yes. State prevailing wage rules are separate and can define covered workers, exempt work, and sites differently from the federal subpart, so check both.